Traditional rubber test methods, such as tensile stress strain testing, Mooney viscosity and scorch, curemeter testing, hardness, density, etc. have been used for monitoring the quality of mixed batches for the last 40 years and earlier. These tests do detect some quality problems that result from the mixing of rubber in the factory; however, because of the time required to perform each of these tests and the shear number of tests, they are more costly to perform compared to modern day alternatives. Moreover, with the implementation of Six Sigma quality programs, these traditional test methods have been shown not to have the “gage sensitivity” required to solve today's factory problems. These traditional methods were the best tests possible at the time of their development; however through the use of new technologies, the functions of these traditional tests can now be replaced with a faster, more sensitive single test using the RPA and PPA technologies that have been developed for this purpose. Not only is this “single test” more discerning in distinguishing between “good” vs. “bad” batches, but it also reduces the total cost of testing.