StateMix offering centrifuge mixer for variety of viscosities
StateMix has developed a centrifuge type mixer that can blend, disperse and de-gas materials with a wide range of viscosities.
The Vortex Mixer rotates a pail containing liquids or powders with two axes running simultaneously in opposite directions at a high RPM. Operators can adjust the speed and duration according to the viscosity, temperature and types of materials being combined.
The Vortex Mixer can mix up to 5 pounds of material usually within 10 to 40 seconds.
For more information, call 204-697-2586 or visit www.statemix.com.
Series 912 crossheads and inline dies from Guill Tool & Engineering Co. meet the needs of medical product makers for micro tubing, achieving the thinnest walls possible-0.0002 inches, the company claims. The line enables ultra-low-volume extrusion while achieving outstanding savings in high-priced resins used in the applications, the firm said. Available in six standard designs, custom products also can be produced. For more information, contact Kathy Peterson by phone at 401-828-7600.
Lupranate 5143 isocyanate features improved low-temperature stability, clarity and shelf life compared to similar polyurethane raw materials used in coatings, adhesives, sealants and elastomers applications, according to BASF Corp.'s polyurethanes business unit. The carbodiimide-modified diphenylmethane diisocyanate-based raw material is formulated to produce flexible elastomers with high elongation, good impact and tensile strength, low hardness, higher heat distortion temperatures and good tear resistance, the company said. For more information, visit www.basf.com/usa.
A new X-ray sensor from NDC Infrared Engineering offers improved measurement range, single-sided operation and low installation costs. The Model 318 X-Ray Backscatter Sensor provides measurement performance that meets or exceeds the exacting requirements of plastics extrusion, converting, calendering, paper, nonwovens and textile applications, while being simple and inexpensive to install, operate and maintain, according to the company. For more information, contact Lloyd Edelberg by phone at 626-939-3809 or e-mail [email protected]
Engel Canada Inc. has unveiled its Compact series of rubber injection molding machines with a redesigned clamp that integrates a fully automatic mold height adjustment with a short stroke cylinder it said can generate clamp tonnage for a rapid cycle time. The clamp system with pressure pad provides additional stiffness to the platen allowing for lowest deflections, the company said. The machines are available in 440, 660 and 880 ton sizes. For more information, contact Mark Hammond by phone at 519-836-0220.