REP Corp.´s Isothermould distributed power rods keep mold temperatures uniform across the surface of the mold, reducing cure time up to 20 percent. Temperatures could be maintained at ± 3 degrees and in some cases ± 1.5 degrees in every mold cavity, REP said. The Isothermould rods are standard on all G8 injection presses and can be retrofitted onto existing machinery. Contact Ron Dagar by phone at 847-697-7210; fax at 847-697-6829; or e-mail [email protected], for more information.
Rods keep mold temperatures stable
Letter
to the
Editor
Rubber News wants to hear from its readers. If you want to express your opinion on a story or issue, email your letter to Editor Bruce Meyer at [email protected].